Siemens SIMATIC TIM 3V-IE DNP3 User Manual

Configuration in STEP 7
5.6 Configuring networks and network nodes in STEP 7 / NetPro
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
109
●
Own tel. number:
Here, you enter your own telephone number for the network node including the area
code. This telephone number can no longer be changed later in the Properties of
subscriber dialog.
Note
In dial
-up networks, in which another subscriber within the same local network cannot be
dialed with the local area code, it is advisable to enter your own telephone number in the
Own tel. number box (without area code) and to specify the area code in Dialing prefix.
●
PIN number:
For a GSM module, the 4 to 8 digit PIN number must be entered here so that this can be
transferred from the TIM module to the module.
If you have a contract without a PIN, leave the box empty.
Note
If an incorrect PIN is entered, the SIM card in the module might be disabled. If the fault
LED lights up during
connection establishment, the diagnostics buffer of the TIM must be
checked because an entry for a bad PIN is generated here.
● Special service:
This parameter cannot be configured for DNP3 and has no significance.
"AT initialization" tab
Image 5-21 Properties - DNP3 Dial-up Network TIM dialog, AT initialization tab

Siemens SIMATIC TIM 3V-IE DNP3 Specifications

General

Brand	Siemens
Model	SIMATIC TIM 3V-IE DNP3
Category	Control Unit
Language	English