Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
37
●
At least STEP 7 V5.4 Service Pack 4 is required.
As of STEP 7 V5.4 SP4 the following operating systems are supported:
– Windows XP Professional SP2
– Windows Server 2003 SP2
With STEP 7 V5.5 SP1, the following operating systems are supported:
– Windows 7 (32-bit or 64-bit)
The Windows XP mode in Windows 7 is not released.
– Windows Server 2008 (32-bit), without or with SP1
– Windows Server 2008 R2 (64-bit), without or with SP1
There is no guarantee that STEP 7 will run on other operating systems; any attempt to do
so is the responsibility of the user. Refer to the readme of the relevant STEP 7 version for
further details.
●
The devices described in this manual are compatible with the following process control
system versions:
– SIMATIC PCS 7 V7.1 SP2 (basic system for the DNP3 master station)
– SIMATIC PCS 7 TeleControl Server V7.1 SP2 (add-on for telecontrol functions)
The SINAUT engineering software
Components of the SINAUT engineering software and how it is supplied
The SINAUT ST7 Engineering Software is made up of two parts:
●
The SINAUT configuration and diagnostics software
The software is installed on the programming device or on the engineering station.
●
The SINAUT TD7 block library for the CPU (not necessary)
The TD7 library contains software blocks for telecontrol communication. It is not required
for DNP3 TIMs.
The the TD7 software is integrated in DNP3 TIMs as TD7onTIM. It is configured with the
SINAUT configuration software.
How the SINAUT engineering software is supplied
The SINAUT engineering software is supplied on a CD-ROM.
The CD-ROM also contains the following manuals in electronic form (German/English):
● DNP3-TIM - System manual
● SINAUT ST7 - System Manual (volume 1, volume 2)
To Next Page
Loading...
Need help?
General
