Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
TIM DNP3
36 System Manual, 12/2015, C79000-G8976-C253-04
Required software components
Software components
● Configuration software
– STEP 7 V5
STEP 7 is required for the basic configuration.
– SINAUT engineering software
The SINAUT configuration and diagnostics software from this software package is
required for the PG.
● Control center software
SIMATIC PCS 7 TeleControl from the SIMATIC environment can be used as control
center software.
You will find the required software versions in the section Software versions (Page 36).
Software versions
Required software
This manual applies to the following configuration software versions:
●
SINAUT engineering software
Required version: V5.5 + SP1
Order number: 6NH7997-0CA54-0AA0
An already installed full version V5.x can upgraded to the current version with an upgrade
package. You will find the upgrade package under the following article number:
6NH7997-0CA54-0GA0
Information on the upgrade package can be found on the Internet pages of Siemens
Industry Online Support under the following entry ID:
87795994 (http://support.automation.siemens.com/WW/view/en/87795994)
You will find the STEP 7 version required for the SINAUT engineering software in the
"STEP 7" bulleted point below.
●
Operating system for the SINAUT engineering software
For the the SINAUT engineering software you require a Windows operating system
compatible with the installed version of STEP 7.
To Next Page
Loading...
Need help?
General
