Preface
TIM DNP3
4 System Manual, 12/2015, C79000-G8976-C253-04
● New functions of the above firmware version of the TIM:
– New data object "DNP_Cmd01X_R" for the function of the DNP3 Object Group 12 /
Variation 1 in the station
– Expansion of the DNP3 station address range to 65519
– Expansion of the data objects “Dat12D_S / Dat12D_R“ with the data type DWORD
– Expansion of the data objects “Par12D_S / Par12D_R“ to all data types except BOOL
For information on the new and expanded data objects refer to Objects of TD7onTIM
(Page 177) and Data objects: Specific channel parameters (Page 206).
– Expansion of the Security functionality to protect against loading and deleting SDBs
(system data) of the TIM from a PG/PC
See section "Options" tab (Page 130) for information on this.
● Adaptation of the SINAUT engineering software for configuration of the new functions
● Editorial revision
This manual replaces the manual release 06/2014.
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support under at the following address:
49109245 (https://support.industry.siemens.com/cs/ww/en/ps/15939/man)
46636298 (https://support.industry.siemens.com/cs/ww/en/ps/15940/man)
Compatibility with older firmware versions
The DNP3 TIM with the firmware version described here is downward compatible with a
DNP3 TIM with firmware version 2.0.
Hardware and software requirements and compatibility
The hardware components and software versions required for configuration and operation of
the DNP3 TIM modules can be found in the section Requirements for operation - necessary
components and services (Page 31).
There, refer to the information on the compatibility of the SINAUT configuration tool.
To Next Page
Loading...
Need help?
General
