LEDs and connectors
3.2 TIM 4R-IE DNP3
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
57
Table 3- 5 Meaning of the LEDs on the left of the front panel of the TIM 4R-IE DNP3
1 BATF All - If there is a functioning battery installed, the LED is
off.
The LED lights up red if the battery is not inserted in
the battery compartment or if the battery voltage is
2 KBus K bus - Data flow over the backplane bus
The display state changes with each message re-
ceived or sent over the backplane bus.
3 TXD1 RS-232 interface 1 Dedicated line Transmit data
LED is lit constantly and is off while a message is
4 RXD1 RS-232 interface 1 Dedicated line Receive data
As long as receive level (DCD) is detected, the LED
is lit and goes off while a message is being received
5 TXD2 RS-232 interface 2 Dedicated line Transmit data
LED is lit constantly and is off while a message is
6 RXD2 RS-232 interface 2 Dedicated line Receive data
As long as receive level (DCD) is detected, the LED
is lit and goes off while a message is being received
Table 3- 6 Meaning of the LEDs on the right of the front panel of the TIM 4R-IE DNP3
7 SF All Group error
Indicates missing or bad parameter settings and RAM errors.
9 P 1 Ethernet Connection to Ethernet (interface 1)
LED lights up yellow if there is a physical connection to Ethernet.
Green flashing LED indicates data flow.
LED is off when there is no physical connection to Ethernet.
10 P 2 Ethernet Connection to Ethernet (interface 2)
LED lights up yellow if there is a physical connection to Ethernet.
Green flashing LED indicates data flow.
LED is off when there is no physical connection to Ethernet.
11 RUN - Module in RUN
LED is lit when the module completes startup without error or is
switched to RUN mode by the PG.
LED is off when the module is switched to STOP mode by the PG.
12 STOP - Module in STOP
LED is lit when the module is switched to STOP mode by the PG.
LED is off when the module is switched to RUN mode by the PG.
To Next Page
Loading...
Need help?
General
