Service cases - hardware
4.14 Sensor Modules Cabinet
Hardware and Software
182 Service Manual, 03/2011, 6FC5397-5DP40-0BA0
Procedure:
1. Withdraw the electronics power supply connector X524 and label.
2. Unscrew the encoder connecting cable at X520 or X521 / X531, if required, also the
shield connection.
3. Withdraw the DRIVE-CLiQ cable X500 and write the slot designation on the cable.
4. Release the protective conductor connection and write the position designation on the
cable.
5. Push the lug downwards.
6. Swivel the module to the front.
CAUTION
The 50 mm clearances above and below the components must be observed.
4.14.4 This is how you install an SMC10/SMC20
Installing
Procedure:
1. Place the components on the mounting rail.
2. Then, swivel the components on the mounting rail so that the mounting catches click into
place at the rear.
3. Slide the components along the mounting rail to either the left or right up to their final
position.
4. Screw on the protective conductor connection.
5. Screw on the encoder connecting cable to X520 and X521 / X531, if required, also the
shield connection.
6. Insert the DRIVE-CLiQ cable at X500.
7. Insert connector X524 for the electronics power supply.
CAUTION
The 50 mm clearances above and below the components must be observed.
To Next Page
Loading...
Need help?
General
