Simplicity Broadmotor Series User Manual

3 - 5
3 Maintenance
Engine Service
Figure 5. Engine Compartment
-Kohler Single Cylinder Engine
A. Battery D Oil Fill/Dipstick
B. Oil Filter E. Fuel Filter (Not Shown
C. Air Filter F. Throttle/Choke Cable
D
C
B
A
E
F
ACCESSING THE ENGINE
To gain access to the engine, unhook the rubber straps
(Figure 4) and tip the hood forward.
NOTE: For engine service item locations see Figure
6 for models with Briggs & Stratton engines and
Figure 5 for models with Kohler engines
FUEL FILTER REPLACEMENT
The fuel filter (E, Figures 5 & 6) is located in the fuel line
between the fuel tank and the carburetor.
If filter is dirty or clogged, replace as follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled fuel.
3. Using a pliers, open and slide hose clamps from fuel
filter.
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when finished.
D
C
B
A
E
G
F
Figure 6. Engine Compartment
- Briggs & Stratton Twin Cylinder Engines
A. Battery E. Fuel Filter
B. Oil Filter F. Throttle Cable
C. Air Filter G. Choke Cable
D Oil Fill/Dipstick
Figure 4. Engine Access
Undo Hood
Straps (Both
Sides) and Lift
Hood to access
Engine
D
C
B
A
E
OIL & FILTER CHANGE
Refer to engine manual for specific oil and filter recom-
mendations and oil draining procedures.
CHECK / CHANGE AIR FILTER
Refer to the engine manual for specific air filter service
procedures.
INSPECT & REPLACE SPARK PLUGS
Refer to the engine manual for specific spark plug
replacement procedures.
Not for Reproduction

Simplicity Broadmotor Series Specifications

General

Brand	Simplicity
Model	Broadmotor Series
Category	Tractor
Language	English