socomec ATyS s User Manual


EN
ATYSp - 542001E - SOCOMEC
AnnexeI-3.Keypadprogramming-generalinformation
Programming mode allows product parameter conguration through the keypad:
• It is always accessible when the product is in Manual position
• It is always accessible in AUT with the load on the priority source and priority source available.
The minimum conguration parameters that must be programmed before use are:
• type of network
• nominal voltage
• nominal frequency.
Navigation in the programming menu
• To enter the programming menu press and hold the validation key until “SETUP” appears on the screen.
or
• For parameter access: Press the “up – down” or “left – right” keys to navigate.
Programming
• Navigate to the parameter to be changed and press the validation key.
Note: The product will request a password.
+
+
• Input the password by using the “up – down” keys to change the value and the “left – right” keys to change
the curser position. (The default factory setting is 1000).
• Press the validation key to validate the password and enable programming.
+
+
• Change the parameter value by using the “up – down” keys to change the variable and the “left – right”
keys to change the curser position.
• Press the validation key to validate the change.
• If necessary, navigate to other parameters in the menu, change the value and validate each change.
• To save all changes, press and hold the validation key until “SAVED” is displayed.
Note: After saving, “SAVED” will be displayed for 2s, the product will automatically exit programming mode
and will then return to the main menu.
Exiting programming mode without saving
• To quit programming mode without saving briefly press the “ESC” key. This will allow navigating back to
the main menu.
Note: Whilst in programming mode, should the product remain idle for longer than 2 minutes it will
automatically exit and return to the main menu without saving.

socomec ATyS s Specifications

General

Brand	socomec
Model	ATyS s
Category	Switch
Language	English