socomec ATyS s User Manual

9
EN
ATYSp - 542001E - SOCOMEC
2. INTRODUCTION
ATySp “Automatic Transfer Switching Equipment” (ATSE) is designed for use in power systems for the safe transfer
of a load supply between a normal and an alternate source. The changeover is done in open transition and with
minimum supply interruption during transfer ensuring full compliance with IEC 60947-6-1, GB 14048-11 and other
international TSE standards as listed.
The ATySp is a full load break (switch type) derived transfer switching equipment where the main components are
proven technology devices also fullling requirements in IEC 60947-3 standards.
As a Class PC ATSE, the ATySp is capable of “making and withstanding short circuit currents” assigned to IEC
60947-3 utilization categories of up to AC23A, GB 14048-11, IEC 60947-6-1 and equivalent standards with utilization
categories of up to AC33B.
ATySpmotorisedsourcechangeoverswitchesensure:
• Power Control and Safety between a normal and an alternate source.
• A complete product delivered as a fully assembled and tested solution.
• Intuitive HMI for emergency / local operation.
• Integrated and robust switch disconnection.
• Window with clearly visible position indication I – 0 - II.
• An inherent failsafe mechanical interlock.
• Stable positions (I – 0 – II) non affected by typical vibration and shocks.
• Constant pressure on the contacts non effected by network voltage.
• Energy Efcient with virtually no consumption whilst on the normal, alternate or off positions.
• Quick, easy and safe dual “on-load” emergency manual operation.
(Manual operation is functional with and without the motorization in place).
• Extremely rugged, error free and built in padlocking facility.
• Straight forward installation with effective ergonomics.
• Minimal downtime with the possibility to perform easy maintenance.
• Programmable secure motorization controls interface with remote control.
• Up to 23 user congurable I/O with communication through MODBUS (Ethernet TCP or RS485) Optional
• Webserver access to monitor most parameters available in the ATySp.
• Real time event recording with time stamp and export functionality.
• Load power monitoring with Energy metering capability.
• Engine exerciser for genset management applications.
• ATS conguration through a keypad as well as through EasyCong programming software.
• Integrated auxiliary contacts for switch positions I – 0 - II.
• Dual active “product availability” status feedback for motorisation and ATS controllers.
• Ample accessories to suit specic requirements.
• Fully integrated ATS controller specically designed for Mains / Mains and Mains / Genset applications with
power management and communication capabilities.
• Power supply continuity with power management and communication for most applications.
 Genset
ATyS p
ATyS D20
ATyS p
ATyS D20

socomec ATyS s Specifications

General

Brand	socomec
Model	ATyS s
Category	Switch
Language	English