Prioritizes the color tone of the light source. This is suitable when you want to produce a warm
atmosphere.
White:
Prioritizes a reproduction of white color when the color temperature of the light source is low.
[113] Shooting
White balance
Capturing a basic white color in [Custom Setup] mode
In a scene where the ambient light consists of multiple types of light sources, it is recommended
to use the custom white balance in order to accurately reproduce the whiteness. You can
register 3 settings.
Note
The message [Custom WB Error] indicates that the value is in the unexpected range, for example
when the subject is too vivid. You can register the setting at this point, but it is recommended that
you set the white balance again. When an error value is set, the indicator
turns orange on the
recording information display. The indicator will be displayed in white when the set value is in the
expected range.
If you use a flash when capturing a shot, the custom white balance will be registered with the flash
light. Shoot images with a flash when recalling a setting registered with the flash.
MENU → (Camera Settings1) → [White Balance] → [Custom Setup].
1
Hold the product so that the white area fully covers the circle located in the center
of the screen, and then press the center of the control wheel.
After the shutter sound beeps, the calibrated values (Color Temperature and Color Filter)
are displayed.
2
Select a registration number using the left/right sides of the control wheel, and then
press the center.
The monitor returns to the recording information display while retaining the memorized
custom white balance setting.
The registered custom white balance setting will remain memorized until overwritten by
the another setting.
3
To Next Page
Loading...
Need help?
General
