[Monitor Brightness]: [Manual][±0]
[Display Quality]: [Standard]
The numbers for “Shooting (still images)” are based on the CIPA standard and shooting under the
following conditions:
(CIPA: Camera & Imaging Products Association)
DISP: [Display All Info.]
Focus Mode: [Automatic AF]
One picture is taken every 30 seconds.
The flash strobes once for every two pictures.
The power is turned on and off once every ten times.
The number of minutes for movie shooting is based on the CIPA standard and shooting under the
following conditions:
The image quality is set to XAVC S HD 60p 50M /50p 50M.
Actual shooting (movies): Battery life based on repeated shooting, zooming, shooting stand-by,
turning on/off, etc.
Continuous shooting (movies): Battery life based on non-stop shooting until the limit (29 minutes)
has been reached, and then continued by pressing the MOVIE (Movie) button again. Other
functions, such as zooming, are not operated.
[16] Preparing the camera Charging the battery pack
Supplying power from a wall outlet (wall socket)
Use the supplied AC adaptor to shoot and play back images while power is supplied from a wall
outlet (wall socket). This conserves the camera's battery power.
Note
The camera will not activate if there is no remaining battery. Insert a sufficiently charged battery pack
into the camera.
If you use the camera while power is being supplied from a wall outlet (wall socket), make sure that
the icon (
) is displayed on the monitor.
Do not remove the battery pack while power is supplied from a wall outlet (wall socket). If you
remove the battery pack, the camera will be turned off.
Do not remove the battery pack while the access lamp is lit. The data in the memory card may be
Insert the battery pack into the camera.
1
Connect the camera to the wall outlet (wall socket) with a micro USB cable
(supplied) and an AC adaptor (supplied).
2
To Next Page
Loading...
Need help?
General
