When an A-mount lens and a Mount Adaptor (LA-EA1/LA-EA3) (sold separately) are mounted on the
camera and [ AF System] is set to [Phase Detection AF], [Disp. cont. AF area] is always turned
on regardless of the [Focus Area] settings.
[47] Shooting Auto focus
AF Micro Adj.
Allows you to adjust and register an autofocused position for each lens, when using an A-mount
lens with the Mount Adaptor LA-EA2 or LA-EA4 (sold separately).
In general use, you do not need to adjust the autofocused position using this function. Use this
function only when adjustments are needed for certain focal lengths. Note that the auto focus
function may not be performed at a proper position when using this adjustment.
Hint
It is recommended that you adjust the position under actual shooting conditions. Set [Focus Area] to
[Flexible Spot] and use a bright subject with high contrast when you adjust.
Note
When you attach a lens for which you have already registered a value, the registered value appears
on the screen. [±0] appears for lenses for which a value has not yet been registered.
If [-] is displayed as the value, then a total of 30 lenses have been registered and no new lens can be
registered. To register a new lens, attach a lens for which the registration can be erased, and set its
value to [±0], or reset the values of all the lenses using [Clear].
The [AF Micro Adj.] supports Sony, Minolta, or Konica-Minolta lenses. If you perform [AF Micro Adj.]
with lenses other than the supported lenses, the registered settings for the supported lenses may be
affected. Do not perform [AF Micro Adj.] with an unsupported lens.
MENU → (Camera Settings1) → select [AF Micro Adj.].
1
Select [AF Adjustment Set.] → [On].
2
[amount] → desired value.
The larger the value you select, the farther the autofocused position will be from the
product. The smaller the value you select, the closer the autofocused position will be to
the product.
3
To Next Page
Loading...
Need help?
General
