How to select the count up format for the time code (TC Run)
Rec Run:
Sets the stepping mode for the time code to advance only while recording. The time code is
recorded sequentially from the last time code of the previous recording.
Free Run:
Sets the stepping mode for the time code to advance anytime, regardless of the camera
operation.
The time code may not be recorded sequentially in the following situations even when the
time code advances in [Rec Run] mode.
When the recording format is changed.
When the recording medium is removed.
How to select how the time code is recorded (TC Make)
Preset:
Records the newly set time code on the recording medium.
Regenerate:
Reads the last time code for the previous recording from the recording medium and records the
new time code consecutively from the last time code. The time code advances in [Rec Run]
mode regardless of the [TC Run] setting.
[156] Recording movies
TC/UB Disp. Switch
Allows you to display the time code (TC) and user bit (UB) of a movie by pressing the key to
which [TC/UB Disp. Switch] function has been assigned.
MENU →
(Setup) → [TC/UB Settings] → [TC Run].
1.
MENU → (Setup) → [TC/UB Settings] → [TC Make].
1.
MENU → (Camera Settings2) → [Custom Key(Shoot.)]/[Custom Key(PB)] →
assign the [TC/UB Disp. Switch] function to the desired key.
1
Press the key to which [TC/UB Disp. Switch] is assigned.
Each time you press the key, the monitor display will switch from the movie recording
time counter → time code (TC) → user bit (UB), in that order.
2
To Next Page
Loading...
Need help?
General
