130 TB9300 Installation and Operation Manual
© Tait International Limited April 2024
Appendix D Installing the Firmware Package
Setting Up a Central Package Server
It is beyond the scope of this manual to describe the exact procedure for
setting up a central package server for any particular network. Tait expects
that each customer will configure their own package server according to the
requirements for their network. However, you do need to configure each
base station with the IP address and port of the package server computer:
1. Log in to the base station and select Configure > Base Station >
Miscellaneous.
2. Under Package server, enter the IP address and port number of the
package server.
3. Download the firmware as described in the Help.
If you click ‘Cancel’ while downloading a firmware package, it takes
approximately 20 seconds for the cancellation to take effect and for the
base station to respond.
To Next Page
Loading...
Need help?
General
