Technicolor TB30 User Manual

TB30s SIP Administrator Guide v1.3 Page 6 of 259
Connected a headset
If you will use a headset, plug the RJ45 headset connector into the headset jack port on the back
of your IP Phone (see the Figure 1)
If your external headset supports Electronic Hook Switch (EHS) following DHSG protocol, you
can use your compatible Jabra wireless headset to answer the phone remotely. Just activate your
headset when you hear the ringer and the handset off-hook to connect the call.
You can use EHS (following DHSG protocol) with your compatible Jabra wireless headset (e.g.
Jabra GN9350e) to answer the phone remotely.
Connection
Plug the RJ45 headset connector into the headset jack port on the back right side of your IP Phone.
Figure 2 Headset Connection
Headset Compability.
TB30 supports Jabra and Planronic headsets.
RJ9
Pin-1
Pin-2
Pin-3
Pin-4
RJ45
Pin-1
Pin-2
Pin-3
Pin-4
Pin-5
Pin-6
Pin-7
Pin-8
TB30 handset
MIC+
SPK-
SPK+
MIC-
TB30 headset
DTX
GND
MIC-
SPK+
SPK-
MIC+
3V3
DRX
Table 1 Handset/Headset pin
Jabra Headset Compatibility: To be confirm.
Plantronics Headset Compatibility: http://www.plantro.net/compatibility
- PROFESSIONAL CORDED H-Top HEADSETS with Quick Disconnect plug and U10P-S19 RJ45
bottom cable.
- PROFESSIONAL WIRELESS HEADSETS with electronic hookswitch cable
AUX Wireless headset setup
You can use EHS (following DHSG protocol) with your compatible wireless headset to answer the
phone remotely. Please read wireless headset's user manual and set it to DHSG mode.
Using headset
Answer and end calls
Headset key on phone keypad
Talk button (EHS): build-in electronic hook switch (wireless headset only)

Technicolor TB30 Specifications

General

Brand	Technicolor
Model	TB30
Category	IP Phone
Language	English