TB30s SIP Administrator Guide v1.3 Page 1 of 259
Part 1 Safety Information
Operating conditions
This telephone is to be operated on a local area network. The telephone must be equipped with
the appropriate software version. This guide is written for the actual version of firmware v1.72
Location safety instructions
Do not expose the IP Phone to fire, direct sunlight or excessive heat.
Do not expose the IP Phone to rain or moisture and do not allow it to come into contact with water.
Do not install the IP phone in an environment likely to present a THREAT OF IMPACT.
The IP phone must be installed at least 1 meter from radio frequency equipment, such as TVs,
radios, hi-fi or video equipment (which radiate electromagnetic fields).
The IP phone is designed to work in temperatures from 0°C to 40°C.
Care
You may clean the IP phone using a fine damp cloth. Never use solvents (such as
trichloroethylene or acetone), which may damage the phone‟s plastic surface and LCD screen.
Never spray the phone with any cleaning product whatsoever.
Connections
Equally, incorrect reassembly could cause electric shock on re-use of the appliance.
The IP Phone must be powered using the power adaptor or PoE.
If you do use an alternative power adaptor, it must comply with the following standards:
- EN60950, CE mark, U/L
- Output: 12VDC /1A.
Any damage caused to the IP Phone as a result of using unsupported power adaptors will not be
covered by the manufacturer‟s warranty.
Do not connect the LAN/PC ports to any network other than an Ethernet network.
Do not work on the system or connect or disconnect cables during lightning storms.
Before working on any system fitted with an ON/OFF switch, turn OFF the power and unplug
the power cord.
To Next Page
Loading...
Need help?
General