TB30s SIP Administrator Guide v1.3 Page 151 of 259
Number display in Standby
TB30s is able to show a different number in standby that the one used for
registration. For this purpose, two new parameters have been included in
section [sip] of common or MAC config files in each profile.
DisplayNumFlag value is disabled by default
DisplayNum could be any char. The maximum number of digits is 20. It
shall not replace any parameter of the sip profile (display name, phone
number, auth name), it‟s only affecting the displayed info on the screen.
The default setting would be:
DisplayNumFlagX=0 , where X is profile 1,2,3,4
DisplayNumX=
Example:
DisplayNumFlag1=1
DisplayNum1=2001
On profile 1, the option of number display is enable. As a result, the 2001
will be used and replaced the default telephone number displaying on the
phone screen.
Remark:
Hide_Phone_Number_Display have priority over DisplayNumFlagX.
Hide_Phone_Number_Display=1 and DisplayNumFlagX =1. Number is Not
Show in strandby.
"DisplayName" is still shown on the screen and in the same position,
independently of DisplayNumFlagX and DisplayNumX value.
Feature Activation
A) Through APS:
In Common or Mac Config file, user is enable or disable the number display
flag to 0 or 1 respectively. Default value is 0.
[sip]
…
DisplayNumFlag1=0 (Default telephone number will be used and displayed on screen)
DisplayNumFlag2=0
DisplayNumFlag3=0
DisplayNumFlag4=1 (DisplayNum will be used and replace the default number displaying on
the screen)
DisplayNum1=
DisplayNum2=
DisplayNum3=
DisplayNum4=2001 (max digits is 20)
…
B) Through Telnet:
To configure, open a command line console, and telnet the phone:
To Next Page
Loading...
Need help?
General