TB30s SIP Administrator Guide v1.3 Page 242 of 259
GetParameterAttributes
This method may be used by a Server to read the attributes associated with one or more CPE Parameter.
SetParameterAttributes
This method may be used by a Server to modify attributes associated with one or more CPE Parameter.
Reboot
Reboot the device
Upload
This method may be used by the Server to cause the CPE to upload a specified file to the designated
location.
Download
This method may be used by the Server to cause the CPE to download a specified file from the
designated location. Now TB30 support below file Download:
FactoryReset
This method resets the CPE to its factory default state.
Detail descrition of Download
Download supported file
TB30 support most Firmware and configure file download. See detail with below table: