Introduction
TLA5000 Series Service Manual
xix
Adjustment and Certification Interval
Generally, you should perform the adjustments and certification (calibration)
described in the Performance Verification and Adjustment Procedures chapters
once per year, or following repairs that affect adjustment or calibration.
Strategy for Servicing
This manual supports and contains information needed for periodic maintenance
of the logic analyzer.
This manual supports and contains informaiton for corrective maintenance of this
product:
H Supports isolation of faults to the failed circuit board or assembly level
shown in the replaceable parts list of Chapter 10
H Supports removal and replacement of those boards or assemblies
H Supports removal and replacement of the fuse, knobs, chassis, and other
mechanical parts listed in the replaceable parts list
This manual does not support component-level fault isolation and replacement.
Service Offerings
Tektronix provides service to cover repair under warranty as well as other
services that are designed to meet your specific service needs.
Whether providing warranty repair service or any of the other services listed
below, Tektronix service technicians are equipped to service the logic analyzer.
Services are provided at Tektronix Service Centers and on-site at your facility,
depending on your location.
Tektronix warrants this product for one year from date of purchase. The warranty
is located behind the title page in this manual. Tektronix technicians provide
warranty service at most Tektronix service locations worldwide. The Tektronix
product catalog lists all service locations worldwide, or you can visit us on our
Customer Services World Center web site at:
Tektronix.com/Measurement/Service
In addition to warranty repair, Tektronix Service offers calibration and other
services which provide solutions to your service needs and quality standards
compliance requirements.
Warranty Repair Service
Calibration and Repair
Service
To Next Page
Loading...
Need help?
General
