Removal and Installation Procedures
6-16
TLA5000 Series Service Manual
Hard Disk Drive
1. Remove the top and right trim and the top-right cover.
2. Set the instrument so its bottom is down on the work surface and the front
panel is facing you.
3. Locate the Hard Disk Drive in the locator diagram in Figure 6--5 on
page 6--14.
4. Remove the two T-15 Torx-drive screws that secure the hard disk drive to the
chassis.
5. Pull the hard disk drive away from the chassis so that you can disconnect the
ribbon and power cables.
6. Disconnect the ribbon and power cables and then remove the hard disk drive
from the chassis.
7. Remove the two T-15 T orx-drive screws that secure the bracket to hard disk
drive.
8. To reinstall the hard disk drive, reverse steps 1 through 7. When installing
the assembly in the chassis, align the two tabs from the bracket to the slots in
the chassis before tightening the Torx-drive screws. Tighten the T-15
Torx-drive screws to 8-in lbs.
CD Drive
1. Remove the top and right trim and the top-right cover.
2. Set the instrument so its bottom is down on the work surface and the front
panel is facing you.
3. Locate the CD Drive in the locator diagram in Figure 6--5 on page 6--14.
4. Remove the single T-15 Torx-drive screw that secures the CD Drive
assembly to the chassis.
5. Pull the assembly away from the chassis so that you can disconnect the
ribbon and power cables.
6. Disconnect the ribbon and power cables and then remove the hard disk drive
from the chassis.
7. Remove the four Phillips screws that secure the CD drive to the bracket.
8. Gently pull the CD drive away from the connector and remove the drive
from the bracket.
To Next Page
Loading...
Need help?
General
