To Next Page

To Previous Page

Unit Operation with TG-VI Controller

Selecting CYCLE-SENTRY or

Continuous Mode

NOTE: The CYCLE-SENTRY icon will appear when the

CYCLE-SENTRY mode is selected and the O

N/OFF switch is

in the O

N position.

Continuous Mode: When Continuous mode is selected, the

unit will run continuously to maintain the setpoint and provide

constant airflow.

CYCLE-SENTRY Mode: : When the CYCLE-SENTRY

Mode is selected, the unit starts and stops automatically as

required to maintain the setpoint and to keep the engine warm

and the battery charged.

1. The unit must be turned on. Clear all alarms.

2. Press the S

ELECT key (cycling arrows) until the display

shows CYCLS and YES or NO.

3. Press the U

P or DOWN keys to choose YES or NO. YES

operates the unit in CYCLE-SENTRY. NO operates the

unit in Continuous Run.

4. Press the E

NTER key (equals sign) when the desired mode

is shown in the display.

NOTE: The E

NTER key must be pressed within 10 seconds to

load the new mode.

The display will briefly show Lod (load) and then the new

mode will appear.

1. Select Key 3. Down Key

2. Up Key

Figure 24: Selecting CYCLE-SENTRY

or Continuous Mode

ANA11