To Next Page

To Previous Page

Loading and Enroute Inspections

Post-Loading Inspection

Post-loading inspections ensure the cargo has been loaded

properly. To perform a post-load inspection:

1. Inspect the evaporator outlets for blockage.

2. Turn the unit off before opening the cargo box doors to

maintain efficient operation.

NOTE: The unit can be operated with the cargo box

doors open if the truck is backed into a refrigerated

warehouse and the dock door seals fit tightly around the

trailer.

3. Perform a final check of the load temperature. If the load

is above or below temperature, make a final notation on

the manifest.

4. Close or supervise the closing of the cargo box doors.

Make sure they are securely locked.

5. Make sure the setpoint is at the temperature listed on the

manifest.

6. If the unit was stopped, restart using the correct starting

procedure. See the Operating Instruction chapter in this

manual.

7. Start a manual defrost cycle 30 minutes after loading. See

the Manual Defrost procedure in this manual.

8. Push the microprocessor controller access door firmly

closed.

CAUTION: Cargo must be pre-cooled to the proper

temperature before loading. The unit is designed to

maintain temperature, not cool an above-temperature

load.

CAUTION: Push the controller access door firmly

closed after each use. Unit damage can occur in

transit if the door is not properly closed.