Toshiba B-EV4 Series User Manual

- 13 -
(2) Storing PC interface commands
NOTES: (1) The storage of PC commands is only performed if it is required.
(2) When the SD card is used, and the SD Card Format Command is not sent before storing
already stored PC interface commands, memory will be taken up with every such storing.
(3) When the SD card is used, and another operation (storing writable characters or logos,
label issue operation) is performed after storing PC interface commands, the image
buffer will be cleared automatically.
(4) Select commands to be stored as the occasion demands.
(5) If another storing operation does not take place after storing PC interface commands, the
printer enters the online mode (label issue operation) after about 10 seconds. In this
case, when the SD card is used, the image buffer will be cleared automatically.
Power ON
<New>
Flash Memory
Format Command
Bit Map Font Data Command
No
Yes
(Add/change)
[ESC] J1: Formats the flash memory on the
memory board.
Completion of
all storing
 Storing writable characters or logos
 Label issue o
p
eration
No
Yes
[ESC] XO: Declares the start of saving PC interface
commands.
Save Start Command
Label Size Set Command
Position Fine
Adjust Command
Print Density Fine
Adjust Command
Image Buffer Clear Command
Line Format Command
Bit Map Font Format Command
Outline Font Format Command
Bar Code Format Command
Save Terminate Command
[ESC] D: Sets the label size.
[ESC] AX: Adjusts the feed length, cut position, and
back feed length.
[ESC] AY: Adjusts the print density.
[ESC] C: Clears the image buffer.
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the bar code format.
[ESC] RC: Draws data of the bit map font.
[ESC] XP: Declares the termination of saving PC
interface commands.

Toshiba B-EV4 Series Specifications

General

Brand	Toshiba
Model	B-EV4 Series
Category	Printer
Language	English