Copying Functions
4-13
4
Paper Output
You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE: Optional output destinations include the job separator, 1,000 sheet document finisher, 4,000 sheet
document finisher, and mailbox.
The table below shows the available output destinations.
NOTE: To change the default destination for copies, refer to Paper Output on page 9-15 for details.
When [Heavy 3] (164 g/m
2
- ) or higher is set in Paper Weight and Mailbox (Option) is set for the output
destination, the output destination is automatically changed to a tray that can be used.
Use the procedure below to select the output destination.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Org./Paper/Finishing] and then [Paper
Output].
4 Select the output destination for finished copies.
5 Press [OK].
6 Press the Start key to start copying.
Destination Description
Inner tray*
* This cannot be selected when the optional document finisher is installed.
Inner tray of the machine (where copies are stored)
Finisher Left Tray
Finisher Top Tray
Tray of the optional 1,000 sheet document finisher
Tray A, Tray B, Tray C Trays A to C in the optional 4,000 sheet document finisher
Right Tray Optional right job separator
Job Separator Tray* Optional Inner job separator
Tray 1 to 7 Trays 1 to 7 in the optional mailbox (tray 1 is the top tray)
To Next Page
Loading...
Need help?
General
