Preparation before Use
2-44
Loading Originals
Follow the steps below to load originals for copying, sending or storing.
Placing Originals on the Platen
You may place books or magazines on the platen in addition to ordinary sheet originals.
1 Open the platen Cover or the optional document
processor.
NOTE: Before opening the document processor, be
sure that there are no originals left on the original table
or on the original eject table. Originals left on the
original table or on the original eject table may fall off
when the document processor is opened.
When placing books or magazines on the machine, do
so with the platen Cover or the optional document
processor in the open position.
Shadows may be produced around the edges and in the
middle of open-faced originals.
2 Place the original. Put the scanning side facedown
and align it flush against the original size indicator
plates with the back left corner as the reference
point.
NOTE:
For details on Original Orientation, refer to
When placing originals on the platen on page 4-9.
To Next Page
Loading...
Need help?
General
