– Using a screwdriver, for example, press small lever -1- for pull
rod into groove -2-. When doing this, button -3- is pushed back
into installation position.
-I- Push button in pressed position
-II- Push button in installation position
Note
♦
Only press the lever into the groove and no further.
♦
Do not clip the trim of the handle onto the selector mechanism
until the handle has been fitted. This makes it possible to check
whether the small lever engages in the tie rod when the push
button is pressed.
2.5 Removing and installing selector mech‐
anism
⇒ “2.5.1 Removing and installing selector mechanism with selec‐
tor lever cable”, page 62
⇒ “2.5.2 Removing and installing selector mechanism without se‐
lector lever cable”, page 64
2.5.1 Removing and installing selector mech‐
anism with selector lever cable
Brief description
In the interior the centre console is to be removed.
The heat shield beneath the vehicle must be removed.
Removing
– Remove selector lever handle ⇒ page 59 .
– Remove centre console ⇒ General body repairs, interior; Rep.
gr. 68 ; Centre console; Removing and installing centre con‐
sole .
– Separate electrical connector from selector mechanism to ve‐
hicle wiring harness.
– Remove air filter housing ⇒ Rep. gr. 23 ; Air filter; Removing
and installing air filter housing .
Golf 2013 ➤
7-speed dual clutch gearbox 0CW - Edition 10.2012
62 Rep. gr.34 - Controls, housing