❑ Securing battery positive wire ⇒ page 88
13 - Poly V-belt
❑ Checking ⇒ page 88
❑ Removing and installing ⇒ Engine; Rep. gr. 13
❑ Poly V-belt routing ⇒ Engine; Rep. gr. 13
Not illustrated
♦ Nut of B+ wire on rear of alternator: 15 Nm
♦ Nut of wire holder on back of alternator : 3.2 Nm
♦ Poly V-belt pulley without freewheel: 65 Nm
♦ Poly V-belt pulley with freewheel: 80 Nm
♦ Removing and installing ancillary bracket ⇒ Engine; Rep. gr.
13
7.12.2 Removing and installing alternator -C-
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
♦ Locking pin -T10060-
Carry out following procedures:
Removing
– Disconnect battery -A- ⇒ page 4 .
Caution
When battery -A- is disconnected and reconnected, the pro‐
cedure described in the workshop manual must be strictly
observed ⇒ page 4 .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
132 Rep. gr.27 - Starter, current supply, CCS