13 Ignition/starter switch and lock cylin‐
der
13.1 Removing and installing steering lock
housing
Caution
When battery -A- is disconnected and reconnected, the pro‐
cedure described in the workshop manual must be strictly
observed ⇒ page 4 .
The steering lock could be destroyed.
If the steering lock is actuated without lock cylinder, it will block
and must be renewed.
The steering lock must not be actuated without lock cylinder.
Note
If the steering lock is to be removed, the steering column switch
base must first be removed.
Removing
– Disconnect battery -A- ⇒ page 4 .
– Remove steering column switch base ⇒ page 326 .
13.2 Removing and installing lock cylinder
Caution
♦ When battery -A- is disconnected and reconnected, the
procedure described in the workshop manual must be
strictly observed ⇒ page 4 .
♦ The steering lock could be destroyed.
♦ If the steering lock is actuated without lock cylinder, it will
block and must be renewed.
♦ The steering lock must not be actuated without lock cylin‐
der.
Removing
– Disconnect battery -A- ⇒ page 4 .
– Remove steering wheel ⇒ General body repairs, interior; Rep.
gr. 69 .
– Remove steering column trim ⇒ General body repairs, interior;
Rep. gr. 68 .
– Remove steering column electronics control unit -J527-
⇒ page 321 .
– Remove airbag coil connector and return ring with slip ring -
F138- ⇒ page 322 .
– Remove steering angle sender -G85- ⇒ page 323 .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
330 Rep. gr.94 - Lights, bulbs, switches - exterior