6.3.2 Renewing bulb of rear interior light -
W45-
Removing
– Release locking lugs -arrows- and remove trim with lens from
rear interior light -W45- .
– Carefully pull glass-base bulb out of holder -arrows-.
– Renew glass-base bulb (12 V/5 W).
Caution
♦ Do not touch glass envelope when fitting bulb. Fingers
leave traces of grease on the glass envelope, which evap‐
orate when the bulb is switched on and cause the glass
envelope to cloud over.
Installing
Installation is carried out in reverse order of removal.
6.4 Rear interior light -W45- (vehicles with
anti-theft alarm) up to MY2009
The following components are built into the rear interior light -
W45- :
♦ Rear interior light -W45-
♦ Rear left reading light -W11-
♦ Rear right reading light -W12-
♦ Anti-theft alarm ultrasonic sensor -G209-
Components cannot be renewed individually. Complete rear in‐
terior light -W45- must be renewed.
Anti-theft alarm ultrasonic sensor -G209- is not allowed to be
moved from its preset position.
– Renew rear interior light -W45- ⇒ page 414 .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
6. Lights and switches in roof trim 413