Caution
DO NOT attempt to prise or lift off front part of installation frame
(in area of switches) from door trim. This will damage switches!
Prise or lever installation frame from behind only, as shown by
-arrow-.
Removing
– Use removal wedge -VAS 3409- to carefully prise mounting
frame out of door trim -arrow-.
– Disconnect connectors -arrows-.
– Release locking lugs -arrows- and remove the switch module
from the installation frame.
Installing
Installation is carried out in reverse order of removal.
3.6 Removing and installing remote release
button for fuel filler flap and rear lid -
E463-
Note
The remote release button for fuel filler flap and rear lid -E463-
has an integrated button illumination bulb -L76- , which cannot be
replaced separately.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
396 Rep. gr.96 - Lights, bulbs, switches - interior