– Adjust shut lines/gaps to body by pushing in or pulling out
alignment bush -arrow- on headlight.
– Tighten all threaded connections to specified torques
⇒ page 236 .
– Check and readjust headlight to ensure gaps are even all
round.
– Install the radiator grille ⇒ General body repairs, exterior; Rep.
gr. 66 .
– Check headlight functions.
– Check headlight settings and adjust headlights if necessary
⇒ Maintenance ; Booklet 20.1 ; Descriptions of work .
2.5 Renewing bulbs
2.5.1 Renewing headlight dipped beam bulb
Note
♦
The headlight does not have to be removed to change the
bulb.
♦
The diagrams show renewal of the left headlight dipped beam
bulb -M29- for the left headlight.
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
Removing
Only headlight manufacturer Hella:
– Remove cover cap -1-.
Only headlight manufacturer Valeo:
Note
♦
For reasons of clarity, headlight is shown removed in the fol‐
lowing illustrations.
♦
The headlight does not have to be removed to change the
bulb.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
2. Headlights with halogen bulbs (from MY2009) 241