– Unscrew both bolts -arrows-.
Note
When right headlight starter for gas discharge bulb -J427- is
pulled off from headlight housing, electrical connectors are simul‐
taneously disconnected.
– Pull right headlight starter for gas discharge bulb -J427- -1- at
right angles out of headlight housing.
Installing
Carry out installation in the reverse sequence, noting the follow‐
ing:
Caution
Ensure seal is seated correctly when installing right headlight
starter for gas discharge bulb -J427- . The ingress of water will
lead to permanent damage to the headlight.
– Tighten all threaded connections to specified torques
⇒ page 279 .
– Check headlight functions.
4.7 Power output module for headlight
Power output module for left headlight -J667- / power output mod‐
ule for right headlight -J668- is located on the underside of the
respective headlight housing.
4.7.1 Removing and installing power output
module for headlight
Note
The following illustrations show removing or installation of the
power output module for headlight -J668- for the right headlight.
For the left headlight, removing or installation is carried out in the
same way.
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
Removing
– Remove headlight ⇒ page 280 .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
288 Rep. gr.94 - Lights, bulbs, switches - exterior