EasyManuals Logo
Home>Xerox>All in One Printer>DocuPrint C1190 FS

Xerox DocuPrint C1190 FS User Manual

Xerox DocuPrint C1190 FS
233 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #177 background imageLoading...
Page #177 background image
Print Quality
10-14
Blank pages Two or more sheets may be feeding at once.
Remove the paper stack from the tray, fan it, and reinsert it.
The print cartridges are not genuine print cartridges.
Verify that the print cartridges (C/M/Y/K) are genuine cartridges, and replace if
necessary.
The transfer unit is old or damaged.
Replace the transfer unit.
The high-voltage supply is defective.
contact the Fuji Xerox local representative office or an authorised dealer.
Hair-like marks appear in
or around black halftone
printing. / Shadows appear
around areas of dense
black printing
The paper was left unwrapped for a long time (especially in a dry environment).
Replace the paper with the one properly stored. See Paper Storage Guidelines on
page 5-5.
The paper is outside the recommended specification range.
Replace the paper with a recommended size and type, and confirm that your print
driver settings are correct. See About Paper on page 5-6.
The transfer unit is old or damaged.
Replace the transfer unit.
Color around the edge of
printing is incorrect
The color calibration is incorrect.
Adjust the color. See Color Calibration on page 10-17.
Colored dots are printed at
regular intervals (about 70
mm)
The drum cartridge is dirty.
Clean the print cartridge.
Partial blanks, creased
paper, or blotted printing
The paper is damp.
Replace the paper with the one properly stored. See Paper Usage Guidelines on
page 5-3.
The paper is outside the recommended specification range.
Replace the paper with a recommended size and type. See About Paper on
page 5-6.
The transfer unit, or fuser, is not installed correctly.
Reinstall the transfer unit and/or fuser.
The print cartridges are not genuine print cartridges.
Verify that the print cartridges (C/M/Y/K) are genuine cartridges, and replace if
necessary.
Condensation inside the printer causes partial blanks or creased paper.
Turn the printer on, and leave it on, for at least one hour to get rid of the
condensation. If the problems still occurs, contact the Fuji Xerox local representative
office or an authorised dealer.
Symptom Reason/Action

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox DocuPrint C1190 FS and is the answer not in the manual?

Xerox DocuPrint C1190 FS Specifications

General IconGeneral
BrandXerox
ModelDocuPrint C1190 FS
CategoryAll in One Printer
LanguageEnglish

Related product manuals