Loading Paper
5-9
Loading Paper
This section includes:
■ Loading Paper in the Manual Feeder on page 5-9
■ Loading Paper in Tray 1 on page 5-11
Loading Paper in the Manual Feeder
You can print on the following types of media:
■ Plain paper
■ Card stock
■ Labels
■ Envelopes
■ Glossy paper
■ Specialty media including business cards, postcards, trifold brochures, and weatherproof paper
■ Pre-printed paper (paper already printed on one side)
■ Custom size paper
See also:
About Paper on page 5-6
Loading Paper in the Manual Feeder
In addition to plain paper, the Manual Feeder can use various other sizes and types of print media, such as
envelopes.
Make sure of the following points when loading paper in the Manual Feeder.
You can load one sheet of the standard paper (60
– 216 gsm) at a time. The minimum size that can be
loaded in the Manual Feeder is 76.2 x 127 mm (3 x 5”).
■ The dimensions of print media that the Manual Feeder can handle are:
■ Width: 76.2 –215.9 mm
■ Length: 127.0 –355.6 mm
Make sure of the following points to avoid any problems during printing:
■ Load paper one by one in the Manual Feeder.
■ Use high quality paper for laser printers to print at high quality. See About Paper on page 5-6.
■ Do not remove or add paper to the Manual Feeder when printing. Doing so may cause a paper jam.
■ Always load paper short-edge feeds.
Note: Depending on the paper size, loading long-edge feed may be available for custom size paper.
To Next Page
Loading...
Need help?
General
