Machine Connection
Phaser 4622
System Administrator Guide
9
AppleTalk, NetWare and TCP/IP protocols ethernet can be switched automatically according to the
applied ethernet transmission protocol.
The Ethernet interface will automatically detect the speed of your network. The machine supports
hub/switch speeds of:
•Auto
• 10 Mbps Full-Duplex
• 100 Mbps Full-Duplex
• 1000 Mbps Full-Duplex
• 10 Mbps Half-Duplex
• 100 Mbps Half-Duplex
Setting the Ethernet speed at the machine
1. Press the Menu button on the machine and select Tools.
2. Enter the Administrator’s Password. The default is 1111.
3. Press the OK button.
4. Select Setup and press the OK button.
5. Select Network Settings and press the OK button.
6. Select Ethernet Speed and press the OK button.
7. Select the ethernet speed to match the speed set on your hub or switch and press the OK button.
8. Press the Menu button to exit the Tools menu.
9. Power off and power on the machine.
Setting the Ethernet Speed using CentreWare Internet Services
1. At your Workstation, open your web browser and enter the TCP/IP Address of the machine in the
Address bar.
2. Press Enter.
3. Click on the Properties tab.
4. Click on the Connectivity link.
5. Click on the Physical Connections link.
6. Click on the Ethernet Link.
7. Select the ethernet speed to match the speed set on your hub or switch.
8. Press Apply to save the change.
Printing a Configuration Report
Follow these steps to print a Configuration Report:
1. Press the Menu button on the Control Panel.
2. Select Information and press the OK button.
3. Select Information Pages and press the OK button.
4. Select Configuration Page and press the OK button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
