Network Installation
Phaser 4622
System Administrator Guide
15
TCP/IP
These instructions describe how to configure the following via CentreWare Internet Services:
• TCP/IP v4 and v6
•Domain Name
•DNS
• Zero Configuration Networking
The device supports TCP/IP versions 4 and 6. IPv6 can be used instead of or in addition to IPv4.
IPv4 Settings can be configured directly at the device user interface, or remotely, via a web browser
using Internet Services. IPv6 can only be configured using Internet Services. To configure TCP/IP
Settings using CentreWare Internet Services, See Configure TCP/IP Settings using CentreWare Internet
Services on page 17.
Configure Static Addressing using the Machine
Information Checklist
Before starting the installation procedure, please ensure that the following items are available and/or
the tasks have been performed:
• Existing operational network utilizing the TCP/IP protocol.
• Ensure that the machine is connected to the network.
• Static IP Address for the machine.
• Subnet Mask Address for the machine.
• Gateway Address for the machine.
• Host Name for the machine.
Procedure
Enter a Static IP Address
1. Press the Menu button on the machine and select Tools.
2. Enter the Administrator’s Password. The default is 1111 and press the OK button
3. Select Setup and press the OK button.
4. Select Network Settings and press the OK button.
5. Select TCP/IPv4 and press the OK button.
6. Select Static and press the OK button.
7. Select IP Address and press the OK button.
8. Use the arrow keys to set the static IP address, then press OK.
9. Use the arrow keys to set the Subnet mask address, then press OK.
10. Use the arrow keys to set the Gateway address, then press OK.
11. Press the Menu button to exit the Tools menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
