Network Installation
Phaser 4622
System Administrator Guide
30
Solaris 2.x
Information Checklist
Before starting the installation procedure, please ensure that the following items are available and/or
the tasks have been performed:
1. Existing operational network utilising the TCP/IP protocol.
2. Ensure that the machine is connected to the network.
3. Static IP Address for the machine.
4. Subnet Mask Address for the machine.
5. Gateway Address for the machine.
6. Host Name for the machine.
Procedure
1. Follow the steps on page 15, then return to this page.
Configure the Client
1. Add the machine printer Host Name to the etc/hosts file.
2. Ensure that you can ping the machine.
3. Use either the GUI method or the tty method as detailed below:
GUI Method
1. Open a command window from the Desktop.
2. Enter su to access Super User mode.
3. Enter admintool to run the System Administrator Tool.
4. Click on Browse:Printers.
5. Click on Edit:Add:Access to Printer....
6. Enter the following information into the Access to Remote Printer form:
a. Printer Name: queuename.
Where queuename is the name of the queue being created.
b. Print Server: hostname.
Where hostname is the machine hostname from the /etc/hosts file.
c. Click on OK to complete the form.
7. Enter sh to run the Bourne shell.
8. Enter the command: lpadmin -p queuename -s hostname !lp to modify the remote queuename.
9. Enter Exit to exit the Bourne shell.
10. Enter Exit to exit Super User mode.
11. Test the queue created, by entering the command:
Note lp -d queuename /etc/hosts.
12. Verify that the job prints at the machine.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
