Xinje DS3 Series User Manual

47
B. The code contents:
Code
Descrption
Standby
Servo OFF (motor power OFF)
Run
Servo ON (motor power ON)
Reset
Servo re-power
Forward Run Prohibited
P-OT ON. Please refer to 5-2-4 “Overtravel Limit”
Reverse Run Prohibited
N-OT ON. Please refer to 5-2-4 “Overtravel Limit”
 Position Control Mode
A. The bit contents:
Bit Data
Description
P5-38
Positioning
Completed (/COIN)
Light when set position and actual position is the same.
Positioning accomplishment width: P5-00 (unit: command
pulse)
P5-36
Near (/NEAR)
Light when set position and actual position is the same.
Near signal width: P5-06
P5-40
Rotation Detection
(/TGON)
Light when the motor speed exceeds the rotation detection
speed.
Rotation detection speed: P5-03 (unit: rpm)
B. The code contents:
Code
Descrption
Standby
Servo OFF (motor power OFF)
Run
Servo ON (motor power ON)
Reset
Servo re-power
Forward Run Prohibited
P-OT ON. Please refer to 5-2-4 “Overtravel Limit”
Reverse Run Prohibited
N-OT ON. Please refer to 5-2-4 “Overtravel Limit”
4-3．Monitoring Mode
U0-XX
Number
Monitor Display
Unit

Xinje DS3 Series Specifications

General

Brand	Xinje
Model	DS3 Series
Category	Servo Drives
Language	English