70
Amod Depth (Amplitude Modulation
Depth)
The Amplitude Modulation Depth setting determines the
depth of the amplitude modulation of the VCA by the
LFO1. Amplitude Modulation adds a cyclical change to
the volume level to create a tremolo effect. Turning the
knob to the right widens the range of the volume
change. Negative value settings reverse the phase of
the LFO1 by 180 degrees.
Settings: -64 ~ +63
Vel Sens (Velocity Sensitivity)
The Velocity Sensitivity setting determines the amplitude
range of the VCA according to playing strength, or
how fast you strike the keys. Turning the knob to the
right (positive values) results in a higher sensitivity,
requiring greater playing strength to increase
amplitude. Turning it to the left (negative values)
requires a lighter touch to increase amplitude. A value
setting of “0” maintains the same amplitude regardless
of playing strength.
Settings: -64 ~ 0 ~ +63
ASSIGN
When KNOB PARAMETER GROUP switch [ASSIGN] is
selected, each of the eight CONTROL knobs can be used
as an individual controller for specified Control Change
parameters which can be freely assigned.
Assign 1-8
As MIDI controllers, knob movements output control
data from the MIDI [OUT] terminal. Turning each knob
to the right increases the value setting for the assigned
parameter. Turning it to the left decreases the value
setting.
Settings: 0 ~ 127
A Control Change parameter can be assigned to each CONTROL knob using the
Control Device and Control Number parameters located in the UTILITY SETUP
menu. For details, see page 95.
You can assign Tempo and Data Entry to be controlled directly by the CONTROL
knobs.
You can confirm the parameter name by pressing the knob’s push-switch.
To Next Page
Loading...
Need help?
General
