To Next Page

To Previous Page

settings configured by your system administrator.

Manage a Paging CallManage a Paging Call

IntroductionIntroduction

During a paging call, you can manage it manually at any time.

ProcedureProcedure

You can do the following:

Select HoldHold to place the current paging call on hold.

The paging call is placed on hold and the receiver releases the session.

Select ResumeResume to resume the held paging call.

The multicast RTP session is re-established.

Select EndEnd to end the paging call.

For CP935W, select .

Advanced Call FeaturesAdvanced Call Features

Call Park and Call RetrieveCall Park and Call Retrieve

Before You BeginBefore You Begin

IntroductionIntroduction

You can park a call, and then retrieve the call either from your phone or another phone. After parked, the call is placed on hold, you can continue the conversation after retrieving it.

Park or Retrieve a Call in the FAC ModePark or Retrieve a Call in the FAC Mode

IntroductionIntroduction

You can park the call to the local extension or the desired extension through dialing the park code.

Park a Call in the FAC ModePark a Call in the FAC Mode

You can park a call in the FAC mode directly. When you park a call to the local extension or the desired extension, the call is held in the same network on your phone.

Before You BeginBefore You Begin

Your system administrator has set call park in the FAC mode.

ProcedureProcedure

1. During a call, select OptionsOptions > Call ParkCall Park.

For CP930W/DD phone, select MoreMore > Call Park(Park)Call Park(Park).

For CP935W, select > ParkPark.

The phone will dial the call park code which is pre-configured.

 NOTENOTE

Call park is not available on all servers. Check with your system administrator to find out if it is available on your phone.

Use Handsets, CP, DD Phones