To Next Page

To Previous Page

ProcedureProcedure

Press on the base station

All the handset that registered to this base station will ring simultaneously and the screen will display the IP address of the base station.

You can press any key on handset to stop ringing, or press again on the base station to stop all handsets ringing.

For CP930W, tap the , , OK key and the End Call soft key;

For CP935W, tap the .

Rename the HandsetRename the Handset

IntroductionIntroduction

The handset will be named automatically if successfully registered to the base station. You can personalize the handset name.

ProcedureProcedure

1. Go to OKOK > SettingsSettings > Handset NameHandset Name.

For CP930W, go to MenuMenu > SettingsSettings > Basic SettingsBasic Settings > Phone NamePhone Name.

For DD phone, go to MenuMenu > Basic SettingsBasic Settings > Phone NamePhone Name.

For CP935W, go to MoreMore > BasicBasic > Phone NamePhone Name.

2. Edit the current name in the Rename/Phone NameRename/Phone Name field.

3. Confirm the action.

Set the Eco Mode+Set the Eco Mode+

IntroductionIntroduction

Eco mode+ turns off the transmission power and the radio waves emitted are virtually zero when the phone is in the standby mode

Before You BeginBefore You Begin

It is only applicable to W53H/W56H/W73H/W78H/W57R/W59R.

About This TaskAbout This Task

You can enable or disable the eco mode+. If the eco mode+ is enabled, there is no signal interactionbetween the handset and the base station, and the color of the signal strength

indicator on the idle screen will be displayed in green. When a call arrives or a connection occurs, the phone exits the eco mode+ automatically, and the color of the signal strength

indicator on the idle screen changes from green to white.

ProcedureProcedure