Zebra LI2208 User Manual

SYMBOLOGIES 8 - 23
Code 128
Enable/Disable Code 128
Parameter # 8
To enable or disable Code 128, scan the appropriate bar code below.
Set Length(s) for Code 128
Parameter # L1 = 209, L2 = 210
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Set length(s) for Code 128 to any length, one or two discrete lengths, or lengths
within a specific range. The default option is Length Within Range. The range is 1 to 80.
• One Discrete Length - Select this option to decode only Code 128 symbols containing a selected
length. Select the length using the numeric bar codes in Appendix H, NUMERIC BAR CODES. For
example, to decode only Code 128 symbols with 14 characters, scan Code 128 - One Discrete Length,
then scan 1 followed by 4. To correct an error or change the selection, scan Cancel on page H-3.
• Two Discrete Lengths - Select this option to decode only Code 128 symbols containing either of
two selected lengths. Select lengths using the numeric bar codes in Appendix H, NUMERIC BAR
CODES. For example, to decode only Code 128 symbols containing either 2 or 14 characters, select
Code 128 - Two Discrete Lengths, then scan 0, 2, 1, and then 4. To correct an error or change
the selection, scan Cancel on page H-3.
• Length Within Range - Select this option to decode a Code 128 symbol with a specific length
range. Select lengths using numeric bar codes in Appendix H, NUMERIC BAR CODES. For example,
to decode Code 128 symbols containing between 4 and 12 characters, first scan Code 128 - Length
Within Range. Then scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To correct an
error or change the selection, scan Cancel on page H-3. This is the default option.
• Any Length - Select this option to decode Code 128 symbols containing any number of characters
within the linear imager’s capability.
*Enable Code 128
(01h)
Disable Code 128
(00h)
NOTE When setting lengths for different bar code types, enter a leading zero for single digit numbers.

Zebra LI2208 Specifications

General

Type	Handheld bar code reader
Wavelength	617 nm
Sensor type	Linear
Scanner type	1D
Read rate (max)	547 reads/s
Pitch reading angle	-65 - 65 °
Motion tolerance (cm/s)	63.5
Linear (1D) barcodes supported	Code 11, Code 128, Code 39, Code 93, EAN-13, EAN-8, GS1 DataBar Expanded, Interleaved 2 of 5, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Not supported
Input voltage	5 V
Power consumption	165 mA
Power source type	DC
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Certification	EMC FCC Part 15 Class B, ICES 003 Class B, IEC 60601-1-2 Environmental RoHS Directive 2002/95/EEC Electrical Safety C22.2 No. 60950-1, EN 60950-1, IEC 60950-1, UL 60950-1 LED Class 1
Product color	Black
Housing material	-
International Protection (IP) code	IP42
Sustainability certificates	RoHS

Weight and Dimensions

Depth	99 mm
Width	67 mm
Height	160 mm
Weight	140 g