Battery chargin
Caution: Always disconnect the negative terminal first when removing the battery and always
connect the positive terminal first when fitting the battery. When connecting the battery leads make
sure not to reverse the polarity. Quick charging will reduce battery life. Disconnect the terminals
rior to char
in
the batter
to avoid dama
e to the circuit and electrical instruments
Battery Disconnect
The function of the battery disconnection switch is to disconnect the supply voltage from the
electrical system by interrupting the connection to the battery. The main advantages of this solution
are:
1. Protection of the electrical system from short circuits
2. Reducing battery self-discharge, especially when the machine is shut down for long time
3. Allows maintenance and repair work in safe conditions
Battery disconnector
UCL18NN012
The battery disconnector is located on the front axle bracket under the right front corner of the hood (A).
Turn the battery disconnector handle in the direction of the arrow (B) to disconnect the battery from the
tractor"s electrical installation. To connect the battery to the tractor"s electrical installation, turn the battery
disconnector handle counterclockwise. Battery connection is indicated by a visible green field (1).
(C) The position of the battery disconnector handle when the battery is connected.
(D) The position of the battery disconnector handle when the battery is disconnected.
- A boost charge is only for emergencies. It will partially
charge the battery at a high rate and in a short time.
- When using a boost-charged battery, It is necessary to
recharge the battery as early as possible.
Failure to do this will shorten the battery's service life.
U18N095
To Next Page
Loading...
Need help?
General