Zetor UTILIX HT Series User Manual

Independent PT
O
Your tractor is equipped with 2 Speed rear PTO to suit range of applications and conditions.
Use the PTO switch to engage or disengage rear PTO.
If the driver leaves the seat or is out of the driver's seat while the PTO is operating, the PTO indicator lamp
flashes and emits an audible signal and the PTO stops operating.
Two switches operate the independent PTO.
The PTO indicator lighton the instrument panel indicates the PTO status.
1. If the indicator light is on: PTO rotates.
2. If the indicator light is off: PTO is off.
3. If the indicator flashes: PTO is not currently in motion, but shall be activated when the clutch pedal is
released or the implement is lowered.
1. ON/OFF SWITCH FOR PTO: The PTO ON / OFF switch is located on the right side of the steering
column and can be easily identified by the built-in red indicator light.
When the switch is pressed, the PTO indicator lights up to indicate that the PTO switch and PTO are both in
the ON position. If you press the switch again, the light turns off, indicating that the PTO is off.
2. PTO CONTROL SWITCH: This switch is located near the starting key location on the dash panel. There
are three positions marked for this switch.
z OFF at the center
z MANUAL at the left
z AUTO AT THE RIGHT.
1 - PTO O
n
-Off S/W
2 - PTO Mode S/W
UCL18N017
CONTROLS, INSTRUMENTS & OPERATIONS
48

Zetor UTILIX HT Series Specifications

General

Brand	Zetor
Model	UTILIX HT Series
Category	Tractor
Language	English