Zetor UTILIX HT Series User Manual

Draining oil from engine
1. unscrew the drain plugs, best immediately after terminating the drive or after heating the engine to working
temperature
2. drain oil
3. clean the drain plugs
4. screw the drain plugs back in
Engine oil filter
Using the oil filter wrench, screw the filter anticlockwise to remove it. Lightly lubricate the rubber seal ring on
the new filter with oil, rotate clockwise until the seal reaches the sealing surface, and then rotate another 2/3
turn to tighten it properly.
Pouring oil to engine
Pour the set amount of motor oil engine by filling hole, start the engine and allow it to run for 2 - 3 minutes
with engine revolutions of 750 - 800.
After stopping the engine and settling the level recheck the amount of oil with a dipstick and check the
ti
g
htness of filter, drain
p
lu
g
s and other
j
oints.
MAINTENANCE INSTRUCTIONS
98

Zetor UTILIX HT Series Specifications

General

Brand	Zetor
Model	UTILIX HT Series
Category	Tractor
Language	English