Rear three-point hitc
U18N041
1 - Upper Link
2 - Link Bracket
3 - Stabilizer bar
4 - Extendable Type of Lower Link
5 - Lower Swinging Hitch
6 - Lower Link
7 - Length Adjustment Handle of the Vertical Link
8 - Vertical Link
Adjustment of the stabilizer bars
The stabilizer bars are designed to limit or prevent lateral
movement of the implement.
No clearance is permitted when transporting implements
and when working on slopes, with rollers, mowers,
seeders, drills and similar implements (position 1).
However, a slight clearance (position 2) is necessary
when working with plows, harrows, excavators, cultivators,
etc., especially when working with draft control.
The length of the stabilizer bars is adjusted after removal
of the pin by turning the tensioner through which the
threaded plugs are connected.
U18N042
CONTROLS, INSTRUMENTS & OPERATIONS
To Next Page
Loading...
Need help?
General