Check and service
This section gives full details of the service procedures necessary to maintain your tractor at peak efficiency
while the lubrication and maintenance chart provides a ready reference to these requirements
Service inspections
Service inspections are performed as follows:
The first service inspection at the state of the engine hour counter of 50 EH maximum, but not later than
6 months after commissioning of the tractor. The second service inspection after covering another 200 EH
(at the state of the engine hour counter of 250 EH maximum) but not later than 12 months after the first
service inspection. Next service inspections always after covering another 250 EH but not later than 12
months after the previous service inspection. The service inspections are a part of tractor maintenance. The
services authorized by Zetor will provide professional performance of service inspections according to the
manufacturer's instructions.
Pre-start checks
To avoid problems it is recommended that a range of checks be carried out daily before starting the tractor.
For full details of the items and frequency please refer to the following tables - Periodical check and service
tables.
Engine coolant
Remove the radiator cap and make sure that the coolant
reaches up to the filler neck and that it is clean. Check tha
the correct antifreeze or anti-corrosion mixture is used.
1 - Radiator Cap
2 - Expansion Vessel
UCL18N054
If corrosion of the cooling system is noticeable in the
coolant color, completely drain the system and fill with the
correct mixture of water and antifreeze or corrosion
inhibitor.
1 - Drain Valve
UCL18N055
To Next Page
Loading...
Need help?
General