Use of rops and seat belt
Precaution to avoid tipping
Safe parking of the tractor
Keep riders off tractor
The Roll Over Protective Structure (ROPS) has been
certified to industry and/or government standards. Any
damage or alternation to the ROPS, mounting hard-ware,
or seat belt voids the certification and will reduce or
eliminate protection for the operator in the event of a roll-
over. The ROPS, mounting hardware, and seat belt
should be checked after the first 100 hours of tractor and
every 500 hours thereafter for any evidence of damage,
wear or cracks. In the event of damage or alternation, the
ROPS must be replaced prior to further operation of the
tractor.
The seat belt must be worn during machine operation
when the machine is equipped with a certified ROPS
Failure to do so will reduce or eliminate protection for the
o
erator in the event of a roll over
U18N136
Do not drive where the tractor could slip or tip.
Stay alert for holes and rocks in the terrain, and other
hidden hazards.
Slow down before you make a sharp turn.
Driving forward out of a ditch or mired condition could
cause tractor to tip over backward. Back out of these
situations if possible.
U18N137
Before working on the tractor:
Lower all equipment to the ground.
Stop the engine and remove the key.
U18N138
Do not allow other persons to ride on the tractor besides
the operator.
Persons on the tractor are exposed to the risk of injury,
e.g. due to the impact of a foreign object or falling from the
tractor.
U18N139
To Next Page
Loading...
Need help?
General