Brake and hydraulic system troubleshootin
PROBLEM CAUSE SOLUTION
Brakes
Brakes do not work
Improper clearance
Worn or burned lining
Different left and right
clearances
Adjust the correct clearance
Contact an authorized service center
Adjust the same clearance
Brake pedal does not
return
Defective return spring
Lack of lubricant in joints
Replace the spring
Remove corrosion and lubricate with
lubricant
Hydraulic
system
Three-point hitch does
not respond
Engine speed is too low
Lack of transmission oil
Air leaks from piping
Suction filter plugged
Defective pump
Defective hydraulic valve
Defective cylinder
Increase the engine speed.
Refill oil to the desired level
Repair or replace the piping, replace
the O-ring on the joint and tighten
Clean filter and change oil
Contact an authorized service center
Contact an authorized service center
Contact an authorized service center
Oil leakage from lines
Loose connection
Cracked lines
Tighten the joint
Repair or replace the lines
The relief valve squeaks
while lifting
Stop slipped Adjust the stop
For any other hydraulic problems, please consult your authorized service center, which has the appropriate
equipment to diagnose and repair the entire system.
To Next Page
Loading...
Need help?
General