For instructions, seeTaskStep
Connecting the motor cables and installing the
shrouds (option +B051) (page 136)
Connect the power cables and clear plastic
shrouds to the drive module.
4
Connect the power supply cable to the LCL filter
cooling fan.
Connecting the input cables and installing the
shrouds (option +B051) (page 137)
Connecting the power cables (page 99)
The component manufacturer’s instructionsInstall the remaining parts, for example, air
baffles, cabinet doors, side plates, etc.
5
Installing the drive module and LCL filter module into an
enclosure
See Installing the drive module and LCL filter module into a Rittal VX25 enclosure (page 231)
TasksStep
Mechanical accessories
Attach the plinth to the floor.1
Attach the enclosure frame to the plinth.2
Make the bottom plate with 360-degree grounding entries for power cables. Attach the bottom plate
to the enclosure frame.
3
Attach the punched section to the back of enclosure frame.4
Attach the mounting brackets to the punched section.5
LCL filter module
Install the pedestal to the LCL filter module.6
Install the cooling fan to the LCL filter module.7
Attach the LCL filter module pedestal guide plate to the enclosure bottom plate.8
Attach the drive module pedestal guide plate to the enclosure bottom plate.9
Attach the extraction/installation ramp to the LCL filter module pedestal guide plate.10
To prevent the LCL filter module from falling, attach its lifting lugs with chains to the enclosure frame.11
Push the LCL filter module carefully into the enclosure along the extraction/installation ramp. Work
preferably with help from another person as shown below. Keep a constant pressure with one foot
on the base of the module to prevent the module from falling on its back.
12
Installation example in Rittal VX25 enclosure 135
To Next Page
Loading...
Need help?
General
